On this page
radar
Find the Sensor
Scan the network and identify your device — instructions for all three applications.
Before you scan
The sensor will not appear unless your host adapter is on the same subnet as the sensor. If the device list is empty, fix that first — see Network & host setup.
Scan for devices
Pick your series’ application. You only need the tab that matches your software.
What you should see
| Field | Meaning |
|---|---|
| Address | Current IP — this is what you change in the next step |
| Model | Confirms you are looking at the right unit |
| Status | Streaming / idle. Idle after a successful scan usually means a power problem |
Multiple sensors on one network
If more than one sensor is present, match them by MAC address or serial before changing anything. Two units with the same address produce intermittent results that are hard to untangle afterwards — see Network & host setup.
Next
Sensor found? Confirm it is actually measuring: First point cloud.