On this page
scatter_plot
Confirm the Point Cloud
Verify the sensor is actually measuring before you change any configuration.
Verify first, configure later. A sensor that streams correctly on its factory address is known-good hardware. If you change the IP first and the connection then fails, you cannot tell whether the network or the sensor is at fault.
What to look at
Open the point cloud view in your software and check three things:
| Check | Healthy | Not healthy |
|---|---|---|
| Shape | Walls and objects appear at the right distance and orientation | Everything at 0, or a single ring |
| Stability | Points stay put; noise is a thin band | Cloud flickers or collapses |
| Coverage | Full configured angular span | Wedge missing at one end |
Orientation
Angles increase clockwise seen from above, with zero at the connector face. Confirm this against a known target — a wall straight ahead should show up where you expect it. Mounting rotation is the usual source of a mirrored scene, and it will make every later calibration step wrong.
Common issues at this stage
| Sight | Cause |
|---|---|
| Cloud appears then freezes | Power supply cannot sustain spin-up current |
| Sparse or noisy points on one side | Window or cover in the optical path |
| Only a partial arc | Obstruction, or the sensor is mounted too close to a surface |
| Nothing at all | Sensor found but not streaming — check the software’s device state |
If the sensor does not appear in the software at all, this is the wrong page.
Go back to [Find sensor](/docs/software/find-sensor/) — it is almost always the
host network that is misconfigured, not the sensor.
Next
Once the cloud is stable and correctly oriented, move on to Set IP.