Interaction Test
What to test before handing an installation over, and what a pass looks like.
Calibration makes the geometry correct. This section checks whether the installation behaves correctly for a person walking up to it.
Test order
Work through these in sequence — each one assumes the previous passed.
| # | Test | Pass condition |
|---|---|---|
| 1 | Coverage sweep | Walking the full active area produces a response everywhere, no dead zones |
| 2 | Edge accuracy | Standing at the four corners, the response lands under the person |
| 3 | Latency | Response arrives within the project’s budget (typically < 100 ms) |
| 4 | Multi-target | Two people tracked independently; no swapping of identities |
| 5 | Exit behaviour | Leaving the area releases the interaction cleanly, no stuck state |
| 6 | Ambient light | Works with house lights on, projection bright, and sunlight if applicable |
| 7 | Power cycle | Everything recovers without manual intervention |
Coverage sweep
Walk a grid, not a line. A single pass through the middle will miss exactly the failures that matter — occlusion from a mounting bracket, a blind wedge behind the sensor, and the edges where the scan is least accurate.
Latency
Measure it rather than judging by feel: touch a known point, record the time between the physical event and the visual response. If it is over budget, check the audio/video pipeline before blaming the sensor — the sensor’s contribution is usually a few tens of milliseconds.
Common failures at this stage
| Symptom | Likely cause |
|---|---|
| Tracks in the centre, misses the edges | Calibration geometry or reference points |
| Works standing, fails walking fast | Frame rate or host-side tracking, not range |
| Ghost touches with nobody there | Reflective surface, or direct sunlight into the window |
| Interaction sticks after exit | Host-side state machine, not the sensor |
Handover checklist
- Sensor address recorded in the installation table
- Calibration profile saved and named after the site
- All seven tests above pass
- Someone other than the installer has walked the scene
Next
Something not passing? Go to Troubleshooting.