On this page
cable
Wiring & Power-Up
From box to powered sensor: what to connect, in what order, and what to check.
Before you start
| Need | Note |
|---|---|
| PoE switch or 12 V supply | Matched to your series — see Topology |
| Cat5e or better cable | ≤ 100 m including the patch panel |
| PoE splitter | Only for A / C series |
| Host computer with a free Ethernet port | Wi-Fi cannot discover the sensor |
Wiring order
- Connect the cable to the sensor first, then to the switch.
- Check the link LED on the sensor’s RJ45 socket — it should light as soon as the cable is in, even before power negotiation completes.
- Apply power.
Never hot-plug the sensor's power connector. Standard variants have no soft start
on the inrush path, and repeated hot-plugging degrades the contacts.
Status indicators
| LED | Meaning | Action |
|---|---|---|
| Off | No power, or supply below minimum | Check PoE budget, try option C |
| Slow blink | Booted, waiting for a network link | Check the cable and the switch port |
| Solid | Streaming | Proceed to find the sensor |
Power-up symptoms
| Symptom | Most likely cause |
|---|---|
| Runs a few seconds then stops | Peak current exceeds what the port can deliver |
| Never lights up | Wrong option for your series (12 V sensor on a PoE port with no splitter) |
| Link LED on, no data | Cable fault on the data pair |
Next
With the sensor powered and the link up, set the host network: Network & host setup.